Skip to content
Get Estimate

Commercial Plumbing in Grand Prairie: Backflow, Plants and Repairs

Grand Prairie spreads across Dallas, Tarrant and Ellis counties, with a sliver in Johnson County, and counted 196,100 residents in 2020. Its business base leans industrial, with a defense and aviation history that goes back to World War I.

For a Grand Prairie commercial property, most plumbing needs come down to repairs, drain work, water heaters or the city's backflow program. Send the details through the form and we pass them to an independent, licensed plumber in the area, who inspects the job, quotes it in writing and leaves the decision with you.

Get EstimateCheck your area

Request service

Requests are routed to one local, independent commercial plumber. How this works.

Who needs a backflow assembly in Grand Prairie

Cross connection control here sits with the city's Public Health and Environmental Quality Department. Its page states that most multi-family properties, all commercial and industrial properties and all irrigation meters need a backflow prevention assembly. It also names common commercial cross connections: soda carbonators, irrigation, chemical dispensers, fire lines and pressure washers. Not sure whether your building already has an assembly? Look near the water meter or where the main line enters the building.

Installing a new assembly

For new commercial domestic assemblies, the city's page lists these conditions:

  • A plumbing permit from Building Inspections is required, and only a licensed plumber or irrigator may install or replace the assembly.
  • The department performs the initial test itself, for a listed fee.
  • Above-ground assemblies may not sit more than five feet up unless a permanent platform is provided.
  • Outdoor reduced pressure zone assemblies must sit in a hotbox for freeze protection.
  • New fire lines need a double check detector assembly, tested only by a registered tester employed full time by a licensed fire line contractor.

After that, registered testers file yearly reports online. Our backflow testing page walks through what a test involves.

Plants and long industrial lines

Aircraft production, missile work and manufacturing all run through the city's economy, according to Grand Prairie's Wikipedia article. Industrial buildings like these carry long sanitary runs, trench drains and process connections. Clearing buildup in those lines on a schedule beats clearing it during a shutdown. See commercial hydro jetting. Before the work starts, the pro will want to know where the cleanouts are and whether any line carries process waste, so dig out drawings if you have them.

Creeks and flood history

The West Fork of the Trinity River and Johnson Creek both flow through Grand Prairie, and the same article notes a long history of flooding from Johnson Creek. If your building has taken on water before, ask the pro to check floor drains, sump pumps and cleanouts while they are on site. A backwater valve on the lowest drains is worth discussing too.

Neighboring requests: Irving and Duncanville. Start here for the full service list.

Frequently asked

Does Grand Prairie test new backflow assemblies itself?

For new commercial domestic assemblies, yes. The city's page says its Public Health and Environmental Quality Department performs the initial test. Annual tests after that are done by testers registered with the city.

Why does my outdoor backflow assembly need a box around it?

Grand Prairie requires outdoor reduced pressure zone assemblies to sit in a hotbox for freeze protection. A cracked assembly after a hard freeze is a common repair, and an avoidable one.

What should a plant manager include in a request?

The building's use, the lines involved (process, sanitary, fire or irrigation), any recent failed backflow tests, and the hours when work can happen without stopping production.

Need a commercial plumber on your schedule?

Send the property, the problem and the best time to reach you. A local commercial plumbing company follows up.

Get Estimate