State rules: who may do the work
Plumbing in Texas is licensed by the Texas State Board of Plumbing Examiners. The license follows the person, not the building, so the same state rules apply in Uptown and in Plano. That matters when you manage sites in more than one city: one license check covers the plumber everywhere, even though the city paperwork changes.
The questions below cover license levels, who may work under a license holder, and the extra endorsement for medical gas work. They apply whether the job is a single restroom in a strip center or a full riser replacement in a tower.
City rules: backflow and grease
Water and sewer rules come from the city that serves the property. Dallas Water Utilities runs the backflow test program and the grease rules in its pretreatment program. Irving, Garland, Richardson and the other cities on our service areas page set their own, so a Dallas answer may not fit a suburban property. When in doubt, read the notice your water utility sent. It names the device, the deadline and how the result must be filed, and that notice beats anything you read online, this page included.
Grease and backflow are also where missed dates cost the most. A skipped pump-out or a lapsed test can be a compliance problem before it is a plumbing problem, so put both on the same calendar you use for fire and elevator inspections.
Your paperwork: lease, insurance and bids
The last three questions are about the documents that decide who pays, who is covered and how fast a bid comes back. None of them need a plumber to answer, but all of them shape the job. Pull your lease and your last insurance request before the pro arrives, and the conversation on site gets shorter. When you are ready, send a request.
Frequently asked
Can I get a commercial plumber after hours or on a weekend?
Say so in the form and mark it urgent. Whether a pro can come that night depends on who is available, so we do not promise a time. While you wait, close the fixture stop or the building main, and keep people away from wet floors and electrical panels.
What license does a commercial plumber need in Texas?
Texas law says that, other than a responsible master plumber, a person may not do plumbing unless they hold a license or their work is supervised and controlled by a license holder. Levels run from tradesman to journeyman to master. The state board has a public license search, so look up the pro by name before work starts.
Can an unlicensed helper work on my building?
Under Texas law, yes, if a license holder supervises and controls the work. The license holder does not have to stand over the helper all day, but must train and manage them and review and inspect what they do. If you see a helper alone on site, ask which licensed plumber is responsible for the job and look that person up.
Does plumbing at a medical or dental office need anything extra?
If the job touches medical gas piping, yes. The state board offers a Medical Gas Piping Installation endorsement that is added to a journeyman, master or inspector license. Ask the pro whether they hold it before you schedule that part of the work.
How often does a backflow assembly need testing in Dallas?
Dallas Water Utilities requires a yearly test on high-hazard backflow assemblies. Irrigation devices are tested when newly installed, repaired or replaced, not every year. The tester must be registered with the city's Building Inspection office, and results go in through the city's online reporting portal. See backflow testing for what the test involves.
Can any plumber test my backflow device in Dallas?
No. Dallas wants the tester registered with the city's Building Inspection office and enrolled in the city's online test reporting system. A plumber who works mostly in another city may not be set up for Dallas. Ask before you book.
What happens if a backflow device fails its test?
In Dallas, a device that fails has 30 days to be repaired and retested. Other cities set their own deadlines, so go by the notice from your water provider.
Does every restaurant in Dallas need a grease trap?
Dallas requires a grease trap for any commercial or institutional food service operation. Sizing follows the Dallas Plumbing Code. If you are opening a new kitchen or changing a menu that adds fryers, ask the pro to check whether the existing trap still fits. Our restaurant plumbing page covers the kitchen side.
How often does a grease trap have to be pumped in Dallas?
As often as needed, and never less than every 90 days. Dallas also requires cleaning whenever 25 percent or more of the interceptor holds floating material, sediment, oil or grease. The trap must be fully emptied by a hauler licensed by the state and by Dallas Water Utilities. Details are on our grease trap service page.
Who pays for a plumbing repair, the tenant or the landlord?
Your lease decides, not the plumber. Read the repair and maintenance section for language about fixtures inside your space, shared lines and building systems. If it is unclear, get the landlord's approval in writing before the pro starts, and ask the pro to note on the invoice where the problem was found.
What insurance paperwork should I ask a plumber for?
Ask for a certificate of insurance with your company listed as the certificate holder. In Texas, certificates for Texas risks must use forms approved by the state insurance department, and a certificate cannot add or extend coverage the policy does not have. If your lease or contract needs specific wording, ask the pro's agent for a copy of the endorsements.
How do I get a plumbing number for a tenant finish-out bid?
Send drawings, not just a description. For a Dallas permit, the city's finish-out checklist calls for mechanical, electrical and plumbing plans, and food, ice or beverage areas need scaled floor plans that show fixtures and floor drains. Add the schedule, the ceiling type and whether the space needs a grease interceptor. Our commercial plumbing contractors page covers GC work.